SRY2 SRY4 SRY2-3 Tubular Electric Heater
The working voltage must not exceed 1.1 times its rated voltage value, and the shell should be effectively grounded.
The dimension “B” in the figure must be fully immersed in the oil (and checked regularly) to avoid burning; the heated oil should be free of corrosive gases.
3. The installation dimension hole of this electric heater is Φ65mm.
4. This model heater is designed according to JB2379-78 flowing oil standard, with a surface load of 2-3.8 W/cm².
5. When selecting, the heating size should be determined based on the actual size of the heating medium.
Note: This heater can be directly used in combination with SRY2 and SRY4 models.
Rated voltage: Single phase 220V, Three phase 380V
Working medium: Mineral oil and water, etc., with good heat dissipation effect.
