Main uses of single head heating rod:
Widely used in plastic machinery, molds, cable machinery, alloy die-casting machines, pipelines, chemical industry, rubber, petroleum and other equipment
Precautions for using cast aluminum electric heater:
1. The working voltage must not exceed 10% of the rated value; the relative humidity of the air is not greater than 95%, and there is no explosive or corrosive gas.
2. The wiring part should be placed outside the heating layer and insulation layer, and the shell should be effectively grounded; avoid contact with corrosive, explosive media and moisture; the lead wire should be able to withstand the temperature of the wiring part and the heating load for a long time, and avoid excessive force when tightening the wiring screws.
3. The metal casting heater should be placed in a dry place. If the insulation resistance is lower than 1MΩ due to long-term storage, it can be restored by baking in an oven at about 200 degrees Celsius for 5-6 hours. Or reduce the voltage and energize to heat until the insulation resistance is restored.
4. The metal casting heater should be fixed in position, and the effective heating area must be closely attached to the heated body. No dry burning is allowed. If dust or contaminants are found on the surface, clean them in time before use to avoid affecting heat dissipation and shortening the service life.
5. The magnesium oxide powder at the outlet end of the electric heating tube should avoid contamination and moisture infiltration in the use site to prevent leakage accidents.
